🖧 #150. Layer 3 switch: L3-SW
Without a router, **L3-SW** (a layer 3 switch) must route between VLANs:
1. Turn routing on.
2. Give **interface vlan 20** the address **192.168.20.1/24** and **interface vlan 30** the address **192.168.30.1/24**.
What to set up
- ○ Routing is on
- ○ VLAN 20 SVI
- ○ VLAN 30 SVI
💡 Type the commands one per line, the way you would on a real Cisco device. Short forms work too (conf t, int fa0/1, no shut). Lines like enable, configure terminal, exit and end are fine anywhere.